Furnace, AC, Plumbing and Electrical Service in Holladay

Holladay's 1970s rambler stock has a recurring pattern: 80% furnace, 13 SEER AC, half-rotten galvanized return grilles. We redesign the return and upgrade to a 2-stage system together — doing one without the other leaves money on the table.

• 1970s Holladay ramblers pair an 80 percent furnace with a 13 SEER AC and rotted galvanized returns. We redesign the return and install a two-stage system together.
• Olympus Cove homes get canyon wildfire smoke in late summer. A HEPA bypass on the plenum keeps indoor PM2.5 low when the outdoor reading triples.
• A full system install and a furnace install were our two most recent Holladay HVAC jobs, each sized for the home at 4,350 feet.

Holladay water is very hard (20+ gpg) on a municipal supply. Unsoftened hard water cuts water-heater life 20–30% by scale, slows tankless flow rates, and leaves film on glass and fixtures. A properly sized ion-exchange softener plus under-sink reverse osmosis at the kitchen sink is our baseline plumbing package here, and we match softener capacity to measured grains-of-hardness plus gallons-per-person-per-day — not a one-size spec sheet.

• Water near 20 grains scales water heaters early; we recommend a softener with any new heater and an annual flush.
• 1970s supply lines and water heaters are at the end of their run, and we replace them before they fail in the basement.
• Drain and leak repairs in Holladay are handled by the same licensed plumbers who do our water heater work.

1970s–1990s homes here were commonly spec'd at 100A. Once you stack a modern HVAC system, an EV charger, and a heat-pump water heater on that service, load calcs run right up to code limits — 200A upgrades are the norm.

• 1970s Holladay homes are candidates for panel modernization, and we check panel capacity before a new AC or an EV charger goes on the service.
• Electrical work, including estimates and presold projects, made up 11 of our 51 Holladay jobs last year.
• If a remodel near the Cottonwood Mall redevelopment adds circuits, a 1970s panel usually cannot carry the new load without an upgrade.