Air Conditioner Replacement and Furnace Upgrades in Santaquin

At 5,050 ft, AC tonnage needs ~20% derating from nameplate. We run Manual J with altitude correction — builder-spec units almost always read undersized by our math.

• At about 5,050 feet, AC tonnage needs roughly 20 percent derating from nameplate; we run an altitude-corrected Manual J and builder-spec units almost always read undersized.
• Older Santaquin homes gain the most from furnace efficiency upgrades, and full system installs were among our most recent jobs here.
• Heat pumps work here when adapted for high-altitude cooling cycles rather than installed off a sea-level chart.

Santaquin water is very hard (22+ gpg) on a municipal supply. Unsoftened hard water cuts water-heater life 20–30% by scale, slows tankless flow rates, and leaves film on glass and fixtures. A properly sized ion-exchange softener plus under-sink reverse osmosis at the kitchen sink is our baseline plumbing package here, and we match softener capacity to measured grains-of-hardness plus gallons-per-person-per-day — not a one-size spec sheet.

• Utah Valley water at about 22 grains per gallon shortens water heater life; a softener protects a new tank from day one.
• Older Santaquin homes carry original supply lines and water heaters that were never sized for a modern household.
• A full system install is the right time for a first water heater flush and a softener on the same visit.

Housing stock in Santaquin is mixed, so our electrical work ranges from panel upgrades on 1970s ranches to EV-charger and heat-pump circuit adds in newer builds — plus a steady stream of grandfathered FPE Stab-Lok panels that need to come out for insurance reasons.

• Electrical troubleshooting was among our most recent Santaquin visits; older homes show worn breakers and overloaded circuits.
• Heat pump conversions in older homes often need a dedicated circuit and a load calculation on the panel.
• Newer Santaquin builds usually need a dedicated EV charger circuit added with a permit.