HVAC, Plumbing and Electrical Company Serving Snyderville, Utah

Snyderville new construction follows Park City building code — tighter envelopes, ERV required, and altitude-corrected Manual J. We've got the high-altitude HVAC certifications most valley contractors don't.

• Altitude-corrected Manual J on every install, because Park City building code and 6,400 feet both demand it.
• ERV installation and service for the tight 2000s-and-newer envelopes around Kimball Junction and Silver Springs.
• Hyper-Heat cold-climate heat pumps sized for Zone 7 winters, with HEPA bypass filtration as part of the standard Snyderville new-build bundle.

Snyderville water is moderate (~8 gpg) on a mix of municipal and private well supply. Unsoftened hard water cuts water-heater life 20–30% by scale, slows tankless flow rates, and leaves film on glass and fixtures. A properly sized ion-exchange softener plus under-sink reverse osmosis at the kitchen sink is our baseline plumbing package here, and we match softener capacity to measured grains-of-hardness plus gallons-per-person-per-day — not a one-size spec sheet.

• Newer builds still freeze: we add freeze protection and smart water shutoff valves for owners who travel.
• Moderate water at about 8 grains means softeners are sized smaller than valley defaults, and we test before installing.
• Water heater and hot-water recirculation service so the far bathroom in a newer home gets hot water without the wait.

Newer construction ships with 200A panels, but dedicated EV-charger circuits, hot-tub disconnects, and heat-pump water heaters are rarely pre-wired. We add circuits without pulling a new service.

• Generac standby generators are part of our Snyderville new-build bundle, sized to run the heat pump and ERV through a winter outage.
• Dedicated circuits for heat pumps, ERVs and EV chargers in homes built with the panel capacity to take them.
• Electrical safety inspections before a sale or remodel.