Furnace Replacement in Cedar Hills, Utah
Free in-home estimate · Family-owned · Licensed & insured · Utah-owned since 2006
Quick answer
Furnace Replacement in Cedar Hills, Utah, 1 day response. At Your Service Pros dispatches same-day across Utah County with a transparent dispatch fee waived on approved repair, free in-home replacement estimates, and a written fixed-price quote before any work begins. Licensed and insured in Utah; 566+ verified Google + Yelp reviews. Call (801) 407-9320 or book online.
What homeowners in Cedar Hills should know about furnace replacement
Furnace replacement in Cedar Hills comes with a wrinkle most contractors skip: at this elevation, gas furnaces have to be configured with a high-altitude orifice kit and proper combustion-air adjustments, or they run rich and soot the heat exchanger within a year. Builders rarely do this, so we see plenty of 10-year-old furnaces in Cedar Hills that are running at 70% efficiency instead of the 95% they were sold as. With Cedar Hills winter lows hitting 22°F, an oversized or improperly tuned furnace short-cycles, wastes gas, and dies young. Every furnace we replace gets sized via Manual J, configured for elevation, and combustion-tested with a digital analyzer before we leave.
Heating in Cedar Hills: what we plan for
- Elevation
- about 4,849 ft
- Typical winter low
- about 22°F (Utah County figure)
- Climate zone
- IECC zone 5B, cold and dry
- Homes
- mostly built since 2000
- Gas furnace input at this elevation
- about 11% below its sea-level rating
At about 4,849 ft, a gas furnace is fired about 11% below its sea-level rating (the rule is roughly 4% for every 1,000 ft above 2,000 ft), so a furnace labeled 80,000 BTU input runs at about 71,200 BTU in Cedar Hills. That is why a new furnace in Cedar Hills is sized from a Manual J heating load with the elevation in it, gets the manufacturer's high-altitude setup where it calls for one, and is checked with a combustion analyzer before we leave.
Homes built since 2000 mostly came with builder-grade furnaces that are now 10 to 25 years old. At that age the parts that commonly wear out are the inducer motor, the hot surface igniter and the flame sensor, and on a high-efficiency furnace the condensate drain and trap, which can clog or freeze in a cold snap.
We work across Cedar Hills, including Cedar Hills North, Mesquite and The Preserve.
Heating and cooling made up 34 of the 46 jobs we completed in Cedar Hills in the 12 months to September 2026 (ServiceTitan job counts).
Heating services in Cedar Hills
Why Cedar Hills homeowners pick us for furnace replacement
High-altitude orifice + combustion configuration, required at Utah elevation, frequently skipped by other installers
Manual J heating load calculation, right-sized so your furnace runs longer cycles and lasts 5+ years longer
Combustion analyzer test on every install, verified clean burn, no soot risk, max efficiency
Furnace Replacement FAQ, Cedar Hills edition
How much does furnace replacement cost in Cedar Hills?
For Cedar Hills furnace replacements the price depends on size (60K to 120K BTU), efficiency (80% vs 95%+ AFUE), single-stage vs two-stage vs modulating, and whether ductwork modifications are needed. The in-home estimate is free, and you get the flat-rate price in writing before any work starts.
How long does the install take?
Standard 1-for-1 swap: one day, 5-7 hours. If we're modifying ductwork or relocating the furnace it can run 1-2 days. Winter no-heat emergencies get priority swaps when stock allows.
What efficiency rating should I get?
For Cedar Hills's climate (winter lows around 22°F), 95-97% AFUE high-efficiency furnaces are the sweet spot. They pay back the price difference in 3-5 years through reduced gas bills. 80% AFUE is fine for milder climates; in Utah you're leaving real money on the table.
Should I consider a heat pump instead of a gas furnace?
In Cedar Hills it's worth a real conversation. Modern cold-climate heat pumps work efficiently down to 0°F and below, well below Cedar Hills's typical winter lows. Combined with a backup electric strip or downsized gas furnace ("dual-fuel"), they often beat gas-only systems on operating cost. Utah Power's heat-pump rebate makes the math even better. We model both options at the estimate.
Do you do emergency furnace replacement in Cedar Hills?
Yes, when your furnace dies in January and indoor temps are dropping, we prioritize. We carry common sizes in stock and can usually turn the swap around within 24 hours for 60K-100K BTU residential units. Call (801) 407-9320.
Do you service heat pumps and air conditioners in Cedar Hills?
Yes. We repair, tune up and replace heat pumps, air conditioners and furnaces across Cedar Hills, including Cedar Hills North, Mesquite and The Preserve. Our American Fork office is minutes away.
Other services we offer in Cedar Hills
Ready for your free Cedar Hills estimate?
We come to your home, do a real assessment, and give you a written, fixed-price quote, no obligation, no high-pressure sales.