Furnace Installation in Highland, Utah
Free in-home estimate · Family-owned · Licensed & insured · Utah-owned since 2006
Quick answer
Furnace Installation in Highland, Utah, 1 day response. At Your Service Pros dispatches same-day across Utah County with a transparent dispatch fee waived on approved repair, free in-home replacement estimates, and a written fixed-price quote before any work begins. Licensed and insured in Utah; 566+ verified Google + Yelp reviews. Call (801) 407-9320 or book online.
What homeowners in Highland should know about furnace installation
New furnace installs in Highland need three things most contractors skip: a real Manual J load calc that accounts for the 4,977 ft elevation, a combustion analysis at commissioning to verify the burner is running clean, and correct venting for 96% AFUE condensing models. The wrong-sized furnace is the single most common comfort problem we fix in Highland homes, oversized units short-cycle and leave cold spots, undersized units run flat-out on January nights and still don't keep up. We size every install to the actual heat load with derating built in, install per IFGC and IRC code, and verify with a combustion analyzer before we leave.
Heating in Highland: what we plan for
- Elevation
- about 4,977 ft
- Typical winter low
- about 22°F (Utah County figure)
- Climate zone
- IECC zone 5B, cold and dry
- Homes
- a mix of older and newer homes
- Gas furnace input at this elevation
- about 12% below its sea-level rating
At about 4,977 ft, a gas furnace is fired about 12% below its sea-level rating (the rule is roughly 4% for every 1,000 ft above 2,000 ft), so a furnace labeled 80,000 BTU input runs at about 70,400 BTU in Highland. That is why a new furnace in Highland is sized from a Manual J heating load with the elevation in it, gets the manufacturer's high-altitude setup where it calls for one, and is checked with a combustion analyzer before we leave.
We work across Highland, including Highland Hills, The Ridge, Greenbriar, Summerwind and Wimbledon.
Heating and cooling made up 95 of the 135 jobs we completed in Highland in the 12 months to September 2026 (ServiceTitan job counts).
Heating services in Highland
Why Highland homeowners pick us for furnace installation
Manual J load calc + elevation derate built into every quote - no builder-spec "tonnage by square footage" guessing
Combustion analyzer verification at commissioning - we measure CO, O2, and stack temp to confirm clean burn
10-year parts warranty (industry-leading) plus our written workmanship guarantee
Furnace Installation FAQ, Highland edition
How much does a new furnace cost installed in Highland?
It depends on efficiency (80% AFUE non-condensing, 96% AFUE condensing, or modulating variable-speed), size (60K BTU vs 100K BTU), and venting work for 96% units (a PVC sidewall vent). The in-home estimate is free, and you get the flat-rate price in writing before any work starts.
Should I go 80% or 96% AFUE for my Highland home?
For most Highland homes the 96% AFUE upgrade pays back in 8-11 years on gas savings, usually worth it if you're staying 10+ years. The 80% AFUE non-condensing units last longer (no acidic condensate corroding the heat exchanger), so for short-term stays or rental properties they can be the better long-term call. We'll show both quotes side-by-side at the estimate.
What size furnace do I need for Highland?
The right answer comes from a Manual J load calc, not square footage. A typical 2,000 sq ft Highland home needs 70,000-90,000 BTU input depending on insulation, window orientation, ductwork, and how well-sealed the envelope is. We run the calc on every install.
Do you install all major furnace brands in Highland?
Yes: Trane, Carrier, Bryant, Lennox, Goodman, Rheem, American Standard, York, and others. We don't favor any single brand; we'll recommend based on your duct system, efficiency goals, and budget. AHRI match certification done on every install for warranty + rebate eligibility.
How long does furnace installation take in Highland?
Standard same-spot swap: one day, 6-8 hours. Adding a high-efficiency 96% AFUE where you previously had 80% (requires new sidewall venting): 1-1.5 days. Full HVAC retrofit with new ducts: 2-3 days. We give a firm timeline at the in-home estimate.
Do you offer heat pump systems for Highland homes?
We do. A zoned variable-speed heat pump is the core of our Highland estate package because it handles the multi-zone comfort problem and the elevation at the same time. We size it from a Manual J for your specific home.
Other services we offer in Highland
Ready for your free Highland estimate?
We come to your home, do a real assessment, and give you a written, fixed-price quote, no obligation, no high-pressure sales.